INJECTION
POLYINJECT PU+ can be injected with using 1-component or 2-component injection pumps. The injection pressure should be at least 4 bars. After the worth is finished the injection system shall be allowed to cure for 24 hours and shall be left undisturbed for this time.
CLEANING
Remove the packers once POLYINJECT PU+ is fully cured and mahe good any holes or voids with POLYPOXY BF on dry surface and allow curing. In case of damp surfaces use POLYPUR F.POLYINJECT PU+, POLYPOXY BF and POLYPUR F should be removed from tools, equipment and mixers with an appropriate solvent immediately after use. Hardened material can only be removed mechanically.
SECTION III: STORAGE & SHELF LIFE
Store all material between 100 and 250 C in a cool, covered dry place. Do not expose the containers to direct sunlight and keep away from all sources of heat. In tropical climatic condition, the product has to be stored in an air-conditioned environment and protected from high humidity. The shelf life of the product is 6 months in unopened condition if stored as perr the recommendations, Exposure to high temperature and humidity will result in considerable deterioration the product and reduce its shelf life.
Note: As with all construction chemical products caution should be always be exercised whilst usage. Protective clothing such as gloves and goggles should be worn. Treat any splashes to the shi or eyes with fresh water immediately and seen medical advice. Should any of the product be accidentally swallowed do not induce vomting, but call for medical assistance immediately. Ensure that the container is available for medical attendant to examine any relevant instructions and content details.
Photo Gallery
Call us get it done
When you hire us for construction services, you know you're getting highly qualified professionals who have the expertise and experience to make sure your project is done properly and functions.
Call us on
0529699624
Email us
Info@gsw-tech.com
